Rockwell Automation 44887-PUB, 44887 Enwatch - Manual (Page 33)

Publication GMSI10-UM031C-EN-E - January 2009
Installing the Enwatch 29
Magnitude and phase reading
A magnitude/phase reading is similar to any other data collector in Emonitor.
You set up an overall measurement, using the “Mag & Phase” collection
specification. Then select “1st Order” as the measurement filter (or any other
desired order).
Validating Enwatch measurements
In the Hardware Setup program, when adding or editing an Enwatch unit, you
can set up a validation function to allow the driver to check the channel’s data
before updating the database. This function can be used to filter unwanted
data when the machine is not running, or when some other parameter is not
within the correct bounds.
Click the Channel tab, then double-click in the Validate column to set up the
validation parameters.