Rockwell Automation MinPak Plus DC Drive User Manual - Manual (Page 9)

2:4
Table 2Ć1A. LocalOperator ControlFaceplates
Specify
Operator's
Functions Provided 1
When Using A
MinPak Plus
Controller With:
Operator's
Control
Faceplate
Model
Start/
Stop
SpeedĆ
setting
Pot
TorqueĆ
setting
Pot
Run/
Jog
Selector
Forward/
Reverse
Selector
AutomatĆ
ic/Manual
Selector
Blank Faceplate
(Use with Remote
Station) 14C200 no no no no no no
Basic Features 14C201 yes yes no yes no no
Basic Features Plus
ArmatureĆReversing 14C202 yes yes no yes yes no
Basic Features Plus
Automatic/Manual
Modes of Operation 14C203 yes yes no yes no yes
Basic Features Plus
ArmatureĆReversing
and Automatic/
Manual Modes of
Operation 14C204 yes yes no yes yes yes
Basic Features Plus
Torque Control 14C205 yes yes yes yes no no
Basic Features Plus
ArmatureĆReversing
and Torque Control 14C206 yes yes yes yes yes no
Basic Features Plus
Torque Control and
Automatic/Manual
Modes of Operation 14C207 yes yes yes yes no yes
Basic Features Plus
ArmatureĆReversing,
Torque Control and
Automatic/Manual
Modes of Operation 14C208 yes yes yes yes yes yes
Remote Station
If the application requires the
Operator Control Station to be
remotely located, the following three
steps must be followed:
D Select the blank Remote
Operator Station Cover
Faceplate (Model 14C200)
D Order aRemote Operator
Adapter Kit, Model 14C200. (This
unit provides aconnection point
for the Remote Station.)
D Specify aReliance Remote
Operator Control Station and
then connect it to the Controller.
Refer to Table 2Ć1B.
NOTE: Whenever a reference kit and
remote operator buffer kit are used
without an auto/manual switch, do
the following:
1. Cut the J1 jumper on all
reference kitsused, and
2. Add a jumper from terminal
326 to 426 on the remote
operator buffer kit.