Rockwell Automation 440R MSR312 Configurable Monitoring Safety Relay w/DeviceNet Communications - Manual (Page 3)

Configurable Monitoring Safety Relay with DeviceNet™ Communications
European Communities (EC) Directive Compliance
MSR312-UM001B-EN-P 3
European Communities (EC) Directive Compliance
This product has the CE mark and is approved for installation within the European Union and EEA regions. It has been designed
and tested to meet the following directives.
EMC Directive
This product is tested to meet the Council Directive 89/336/EC Electromagnetic Compatibility (EMC) by applying the following
standards, in whole or in part, documented in a technical construction file:
• EN 50081-2 EMC — Generic Emission Standard, Part 2 — Industrial Environment
• EN 50082-2 EMC — Generic Immunity Standard, Part 2 — Industrial Environment
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is not required to meet Council Directive 73/23/EEC Low Voltage, as it is designed for use with a voltage rating
below 50V for alternating current and below 75V for direct current. The requirements of EN 60947-5-1:1997 Low-Voltage
Switchgear and Controlgear, Part 5 — Control Circuit Devices, have been applied.
Preface
The purpose of this manual is to provide you with the necessary information to apply the MSR312P Safety Relay using
DeviceNet™ with DeviceLogix Component Technology. Described in this manual are methods for installing, configuring, and
troubleshooting the MSR312P DeviceNet.
Intended Audience
This manual is intended for qualified personnel responsible for the setup and service of these devices. You must have previous
experience with and a basic understanding of communications terminology, configuration procedures, required equipment, and
safety precautions.
You should understand the DeviceNet network operations, including how slave devices operate on the network and
communicate with a DeviceNet master.
You should be familiar with the use of the RSNetWorx for DeviceNet Software (Cat. No. 9357-DNETL3) for network
configuration. This software package is referred to often in this manual.
Vocabulary
In this manual we refer to the MSR312P Safety Relay with DeviceNet Communications with DeviceLogix Component
Technology as the “MSR312P.”
Read this manual in its entirety before installing, operating, servicing, or configuring the MSR312P
Safety Relay with DeviceNet communications.
Read the DeviceNet Cable System Planning and Installation Manual, Publication 1485-6.7.1, in its
entirety before planning and installing a DeviceNet System. If the network is not installed
according to this document, unexpected operation and intermittent failures can occur.
If this manual is not available, consult your local Rockwell Automation Authorized Distributor or
Sales Office to request a copy. Copies may also be ordered from the Rockwell Automation
Bookstore. The bookstore can be contacted via the Internet from the Rockwell Automation home
page at http://www.rockwellautomation.com.
Only personnel familiar with DeviceNet devices and associated equipment should plan or
implement the installation, startup, configuration, and subsequent maintenance of the MSR312P
Configurable monitoring Safety Relay. Failure to comply may result in personal injury and/ or
equipment damage.
ATTENTION
ATTENTION