700h control connections – Rockwell Automation 20D PowerFlex 700S/700H Frames 10...14 IP00, NEMA/UL Open Power Structures User Manual
Page 36
36
Rockwell Automation Publication PFLEX-IN020C-EN-P - July 2013
PowerFlex 700S and 700H Frames 10...14 IP00, NEMA/UL Open Power Structures
700H Control Connections
1. To access the ASIC board(s), remove the front protective cover(s) from
the power structure(s) as shown below.
2. Connect the 24V power supply cable between connector X10 on the
ASIC board and connector X2 on the Fiber Optic Adapter or Star
Coupler board on the back of the 700H control board. Refer to figures
22
,
23
and
24
for connector locations.
3. Connect each fiber optic cable between the respective connectors on the
ASIC board(s) and the Fiber Optic Adapter or Star Coupler board. For
frames 10, 11 and 13, refer to
Table 20
on page
37
for cable designations
and connection points and figures
22
and
23
for connector locations. For
frames 12 and 14, refer to
Table 21
on page
37
for cable designations and
connection points and figures
22
and
24
for connector locations.
• Complete fiber optic cable connections after all electrical wiring has
been completed to avoid damage to the cables.
• Ensure that the fiber optic cables do not contact sharp objects that can
cause damage to the cables.
• The fiber optic cables have a minimum bending radius of 50 mm (2.0
in.).
IMPORTANT
Verify correct cable/connector placement. Connecting the wires incorrectly
could damage components.
Frames 13 and 14
Frames 10…12
(Frame 10 shown)
Protective
Covers