Metrohm VESUV - Manual (Page 19)

14
• 2. Connecting devices
Vesuv 3.0
692, 713 pH Meter
Cables
PC 25pin 6.2125.060
PC 9pin 6.2125.110
If possible work with the following RS parameters: 9600
Baud, 8 Data Bit, 1 Stop Bit and no parity. The handshake
must be set as follows:
•
HWs (if the pH Meter is connected to a COM port)
•
SWchar (if the pH Meter is connected via a Softswitch)
The RS parameters can be set on the pH Meter in key
<configuration>, >RS settings.
Settings on the pH Meter
•
Always transmit the print header:
settings under "<config>, >printer"
•
Switch off date/time transmission for each measurement:
settings under "<config>, >print meas.value"
•
Do not switch off sample number:
settings under "<config>, >auxiliaries"
•
Only transmit reports without embedded graphics, i.e.
short reports for calibrations, electrode test, ion meas-
urements