Banner U-GAGE T30UX Ultrasonic Sensors - Manual (Page 8)

Specifications
Sensing Range
“A” suffix models: 100 mm to 1 m (3.9 in to 39 in)
“B” suffix models: 200 mm to 2 m (7.8 in to 78 in)
“C” suffix models: 300 mm to 3 m (11.8 in to 118 in)
Ultrasonic Frequency
“A” suffix models: 224 kHz
“B” suffix models: 174 kHz
“C” suffix models: 114 kHz
Supply Voltage
10 to 30V dc (10% max. ripple) at 40 mA, exclusive of
load
Supply Protection Circuitry
Protected against reverse polarity and transient voltag-
es
Output Configuration
Discrete (switched) output models: SPST solid-state
switch. Configurable as NPN (sinking) or PNP (sourc-
ing) via Mode push button. Normally Open (NO) or
Normally Closed (NC) operation is also selectable via
Mode push button (see
Mode Setup - Output Configu-
ration on page 3).
The default setting is PNP/NO
Output Rating
Discrete output models: 100 mA max.
OFF-state leakage current: NPN: < 200 μA at 30V dc
(see NOTE 1); PNP: < 10 μA at 30V dc
ON-state saturation voltage: NPN: < 1.6V at 100 mA;
PNP: < 3V at 100 mA
Output Protection Circuitry
Protected against short circuit conditions
Output Response Time
“A” suffix models: 45 ms
“B” suffix models: 92 ms
“C” suffix models: 135 ms
Delay at Power-up
500 ms
Temperature Effect
0.02% of distance/°C
Repeatability
“A” suffix models: 0.1% of distance (0.5 mm min.)
“B” suffix models: 0.1% of distance (1.0 mm min.)
“C” suffix models: 0.1% of distance (1.5 mm min.)
Sensing Hysteresis
“A” suffix models: 2 mm
“B” suffix models: 3 mm
“C” suffix models: 4 mm
Minimum Window Size
10 mm (0.4 in)
Adjustments
Sensing window limits: TEACH-Mode of near and far
window limits may be set using the push button or re-
motely via TEACH input.
Output Configuration: NPN, PNP, Normally Open
(NO), Normally Closed (NC) select (see
Mode Setup -
Output Configuration on page 3 or Remote Line
TEACH on page 6).
Advanced configuration options: Push button ena-
bled/disabled, temperature compensation enabled/
disabled (see
Remote Line TEACH on page 6)
Indicators
See Figure 1. Features on page 2
Construction
Housing: PBT polyester
Push buttons: polyester
Transducer: epoxy /ceramic composite
Environmental Rating
Leakproof design, ratedIP67 (NEMA 6)
Connections
2 m (6.5 ft) or 9 m (30 ft) shielded 4-conductor (with
drain) PVC cable, 150 mm (6 in) PUR Euro-style pigtail
(QPMA), or 4-pin integral Euro-style connector (Q8)
Operating Conditions
Temperature: −40 °C to +70 °C (−40 °F to +158 °F)
Humidity: 95% at +50 °C (non-condensing)
Vibration and Mechanical Shock
All models meet Mil. Std. 202F requirements method
201A (vibration: 10 to 60 Hz max., double amplitude
0.06 in, max acceleration 10G). Also meets IEC
947-5-2; 30G 11 ms duration, half sine wave
Application Note
The temperature warmup drift upon power-up is less
than 1% of the sensing distance.
Certifications
CE Pending
NOTE 1: NPN < 200 μA for load impedance > 3 kΩ; for load current of 100 mA, leakage < 1% of load
current
U-GAGE® T30UX Series with Discrete Output
8 www.bannerengineering.com - tel: 763-544-3164 P/N 138381_web
Rev. G