Banner PresencePLUS BCR 1.3 Series - Manual (Page 166)

Port Default IP Address Socket
20,007 192.168.0.1 8
20,008 192.168.0.1 9
20,009 192.168.0.1 10
• The serial port is the RS-232 connector (Pins 1, 9, and 10) on the Sensor. The deafult settings
for the serial port are listed below.
Default Setting Attribute
115200 Baud Rate
8 Data Bits
None Parity
1 Stop Bit
None Flow Control
3. Format the ASCII string of data (in the Format field).
• Choose a Delimiter and Start and End strings.
• Check the Enable Labels box to add the names for data being sent.
Allowable ASCII string options are shown below.
Note: Start and End strings can now accept ASCII Hex values, and the following special
characters: "\r", "\n", "\t".
Description Values Option Name
The delimiter is used to separate
the individual pieces of data being , <Comma>
: < Colon>
Delimiter
sent. The delimiter will follow every
; <Semicolon> individual segment of data,
including start string and end
string.
\r\n <CR_LF> Carriage return and
then line feed
\n\r <LF-CR> Line feed then
carriage return
\r <CR> Carriage return only
\n <LF> Line feed only
This option is a mechanism for
adding characters before a string
of data. User-defined ASCII characters
(limit of 75 characters) Start String
Note: ASCII Hex characters
are allowed. Special symbols
such as \r, \n, and \t will cause
a carriage return, new line,
P/N 000000 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
166
7/2009 PresencePLUS Software Tools