Banner PresencePLUS BCR 1.3 Series - Manual (Page 41)

Possible Inspection
Modifications Result Inspection
Destination Inspection
Source
None required A dialog indicates that the
image color has changed and
the inspection loads Standard grayscale
sensor (for example, a
standard OMNI) Color sensor (for
example, a Color
OMNI)
None required A dialog indicates that the
image color has changed and
the inspection loads Color sensor (for
example, a Color
OMNI) Grayscale sensor
(for example, a
standard OMNI)
Reposition image, adjust ROIs and
tools in the FOV, and possibly
acquire a new reference image A dialog indicates that the
image/FOV has been adjusted
and the image loads the image
into the upper-left of the FOV. Standard VGA sensor
(for example, a
standard AREA
sensor) High Resolution
(1.3) sensor (for
example, an
AREA 1.3 sensor
)
Note that the image may be
cropped at the right and/or
bottom and ROIs may be
outside the image area
Possibly acquire a new reference
image A dialog indicates that the
FOV has been adjusted and
the inspection loads with the
image centered in the FOV High Resolution (1.3)
sensor (for example,
an AREA 1.3 sensor) Standard VGA
sensor (for
example, a
standard AREA
sensor)
Adjust I/O as appropriate A dialog indicates that the
inspection uses I/Os not Sensor with 4 I/O (for
example, an OMNI) Sensor with 6 I/O
(for example, a
ProII)
available on the sensor and
the inspection loads
Retest and modify timings as
appropriate, and possibly acquire
a new reference image A dialog indicates that the
timing was adjusted and the
inspection loads with the
timing(s) adjusted to the Sensor that supports a
smaller maximum
trigger delay, trigger
width, NTSC fail/hold Sensor that
supports a larger
maximum trigger
delay, trigger
maximum time allowed on that
sensor time, or exposure time
(for example, a
standard OMNI width, NTSC
fail/hold time, or
exposure time
maximum trigger delay
set to 8000 ms) (for example, a
ProII maximum
trigger delay set
to 10000 ms)
5.4.2 Inspection Storage Capacity
The INS file format allows for the storage of inspection files onboard every sensor. The table below shows the
storage capacity for the various Vision sensors. Stored inspections can be modified, run, or deleted on the
sensor.
Number of INS files
without Reference
Images* Number of INS Files INS Storage Memory Sensor Type
999 188 64MB Pro II
41 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
P/N 000000
Tools Screen 7/2009