Banner PresencePLUS BCR 1.3 Series - Manual (Page 237)

8.2 Serial Connection
The sensor has a single serial connection that you can configure, Serial 1:
• Serial 1 is the DB-9 connector.
Note: The Pro has 2 serial connections. Serial 2 in the dropdown list is to support those sensors.
The sensor has one serial connection that can be configured: Serial 1 is pins 1, 9, and 10. Set up the serial
communication options to match the receiving device. The following table shows the configuration options:
Default Setting Attribute
115200 Baud Rate
8 Data Bits
None Parity
1 Stop Bit
None Flow Control
To setup a serial connection:
1. Click on the System button in the Main Menu toolbar to bring up the System Setup window.
2. Click on the Communication tab.
3. Choose Serial 1 from the Connection drop-down list of the Communication Tool Setup field.
237 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
P/N 000000
Communication Tool Setup 7/2009