Banner L-GAGE LT7 Series - Manual (Page 21)

P/N 120244 Rev. B
21
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164
L-GAGE® LT7 Long-Range Time-of-Flight Sensor
Accessory Mounting Brackets
SMBLT7
• Right-angle bracket
• 300 series stainless steel
• Fine-adjust accessory available (model SMBLT7F)
SMBLT7F
• Fine-adjust accessory for model SMBLT7 bracket;
bracket sold separately
• 304 series stainless steel
• Mounting hardware included
45.0 mm
(1.77")
3.0 mm
(0.12")
45°
14.0 mm
(0.55") Ø 3.1 mm
(0.12")
18.0 mm
0.71"
16.9 mm
0.67"
32.0 mm
(1.26")
11.0 mm
(0.43")
25.0 mm
(0.98")
49.5 mm
1.95"
53.0 mm
(2.09")
90.5 mm
(3.56")
140.5 mm
(5.53")
20°
10.0 mm
(0.39")
Ø 3.0 mm
(0.12")
14.0 mm
(0.55")
Opening for set screw
(included)
Using the Bracket and Fine-Adjust Accessory
Bolt the two accessories to the base and/or angle of the bracket as shown in the photo above, aligning the small pins in the accessory
with the small holes in the bracket. Install the sensor on the bracket, and the bracket on the mounting surface, using the bracket’s curved
slots for rough alignment. Tighten these bolts finger-tight. Tighten or loosen the SMBLT7F set screws to fine-adjust the sensor alignment
in each axis; then tighten all bolts.