Banner SureCross DX80 Wireless Networks - Manual (Page 5)

Selecting I/O to Populate the Gauges Setup Screen
Nodes and I/O points selected on this screen control the register information displayed on the main Status screen and what devices
populate the drop-down lists on the Gauges Setup screen.
After making any changes, click on the Apply button to save the changes. Click on the OK button to close this screen and return to the
Status screen.
To select a Node to display graphically:
1. Double-click the checkbox to select the Nodes to display on the Status screen or on a gauge.
2. Click once on the Node (listed on the left) to display the list of I/O points on the right.
3. Double-click on the I/O points for that Node to display on the Status screen or to map to a graphical display. For each I/O point,
select an I/O type from the drop-down lists.
4. Click on the next Node to select I/O points.
5. After selecting the Nodes and the I/O points, click the Apply button to save the configuration.
6. Click on the Gauges Setup tab to go to the next gauge configuration screen.
Clicking once on a Node, as shown in the sample screen, will highlight the Node and display a list on the right side. This is the list of all
selected I/O points and the I/O type for this Node.
Setting up the Gauges
Use the Gauge Setup screen to configure each gauge displayed on the Register View screen. Select the gauge type and the Node and
I/O point displayed on each of the four gauges.
After making changes to the settings, click on the Apply button to save the changes and click on the OK button to close the screen and
return to the Status screen.
SureCross User Configuration Tool (UCT)
Rev. G www.bannerengineering.com - tel: 763-544-3164 5