Cisco XR 12404 User Manual
Page 157
5-33
Cisco XR 12404 Router Installation Guide
OL-13830-02
Chapter 5 Maintaining the Router
Removing and Replacing an RP or Line Card
Step 1
Orient the top of the cable-management bracket with the top of the line card
faceplate (the end opposite the two four-character alphanumeric displays.)
Step 2
Align the two captive screws on the bracket with the threaded insert holes near the
ejector levers on each end of the line card faceplate and finger-tighten the screws.
Step 3
Use a flat-blade screwdriver to secure the two captive screws.
Caution
Do not overtighten the captive screws; overtightening the screws can strip the
threads on the screw or the insert in the faceplate.
Step 4
Repeat steps 1 through 3 for any remaining line cards.
Step 5
Attach an appropriate number of velcro straps through the slots in the
cable-management bracket to support the network interface cables (
).
a.
Pull the small end of the velcro strap through the slot in the
cable-management bracket.
b.
Insert the small end of the velcro strap into the slot in the wide end of the
velcro strap.
c.
Pull the small end through the velcro strap slot to secure it to the cable-
management bracket.
todd.book Page 33 Monday, March 16, 2009 2:47 PM