Cisco XR 12404 - Manual (Page 78)

Chapter 3 Installing the Router
Connecting RP and Line Card Cables
3-13
Cisco XR 12404 Router Installation Guide
OL-13830-02
Caution Carefully adjust the interface cable in the RP or line card cable-management
bracket to prevent any kinks or sharp bends in the interface cable. Kinks and sharp
bends can destroy or degrade the ability of the optical fiber to propagate the
signal-encoded beam of light accurately from one end of the cable to the other.
Also, allow adequate strain relief in the interface cable.
Step 3 Route the cable to the chassis cable-management bracket mounted to the left side
of the chassis (
Figure 3-9 ).
• Use the screws packaged with the chassis cable management bracket kit.
Figure 3-9 Chassis Cable-Management Bracket
CONSOLID
ATED SWITCH F
ABRIC
CRITICAL MAJOR MINOR
MBUS
FAIL
ENABLE
ALARM F ABRIC
1 0
2
3
40C48/PO S-SR-SC
TX
RX
ACTIVE CARRIER RX PKT
CLASS 1 LASER PR ODUCT LASERPRODUKT DER KLASSE 1 PRODUIT LASER DE C LASSE 1
PRODUCTO LASER DE CLASSE 1
CLEAN CONNECT OR WITH ALCO HOL WIPES BEFO RE CONNECTIN G
SLO T-0
GIGABIT R OUTE PR OCESSO R
SLO T-1
COLL
LINK TX
RX
RJ-45
MII
RESET
AU X
EJECT
CO NS OL E
66276
todd.book Page 13 Monday, March 16, 2009 2:47 PM