Tweco Pak 200 - Manual (Page 29)

Manual 0-5057 3-3 INSTALLATION
INSTALLATION PAK 200
3.04 Position the Power Supply
WARNING
Do not
touch live electrical parts.
Disconnect input power conductors from de-energized supply line before moving unit.
FALLING EQUIPMENT can cause serious personal injury and equipment damage.
Use all four lifting eyes when using lifting straps to lift the power supply.
Use a forklift, crane, or hoist to lift the unit off the shipping pallet as shown. Keep the power supply steady and
vertical. Do not lift it any further than necessary to clear the shipping pallet.
Art # A-04824
Figure 3-3: Position the Power Supply
Set the power supply on a solid, level surface. The installer may fasten the power supply to the fl oor or a supporting fi xture
with hardware passing through the horizontal parts of the power supply feet.