Profile series v.g1.5 cylindrical lock, Figure 1 figure 3 figure 2, Outside of door – SARGENT Profile Series v.G1.5 Cylindrical Locks User Manual
Page 10
8
800-810-WIRE (9473) • www.sargentlock.com • A7854B
Profile Series v.G1.5 Cylindrical Lock
05/06/09
A7854:B
Copyright
©
2009,
Sargen
t
Manufacturing
Company
,an
A
S
S
A
AB
LO
Y
G
roup
company
.All
right
s
reser
ved
.
Reproduction
in
whole
or
in
par
t
without
the
express
writ
ten
permission
of
S
AR
G
EN
T
Manufacturing
is
prohibited
.
Inside lever
Inside
of door
Inside rose
(C) Lockbody harness
(E) Keypad
harness
(A)
Ground
wire
(F) Controller
connector
Latch
screws
NOTE: For exterior applications, use weather seal gasket part #
(10-0649) between escutcheon and outside door surface
1A. For fire rated doors only, feed ribbon cable connector and
ground wire from outside of door through weather seal gasket
(if used) then fire stop plate.
1B. For non-fire rated doors only, feed ribbon cable connector
and ground wire from outside of door through weather seal
gasket (if used), then conduit sleeve in door (not shown).
2.
Slide the outside escutcheon over the lock and hold
the escutcheon to the door surface.
3.
Prior to installing outside lever, verify cylinder spacer is
inserted into horizontal slot of lock body tube.
4.
Slide the outside lever onto tube with key horizontal
(toward latch). Rotate key 45 degrees clockwise.
5.
Push lever until lever catch is engaged.
6.8–Installation of Outside Escutcheon and Lever
6.9–Inside Escutcheon and Lever
1. Remove black battery cover from the escutcheon with security
wrench (provided).
2. Connect ground wire to terminal E3 (Fig. 1), connect keypad
harness (Fig. 2) to controller, and connect lockbody motor
harness (Fig. 3) to motor connector.
3. Feed all excess wire through inside door hole and into outside
escutcheon cavity, being careful not to pinch wires.
4. Tighten two latch screws completely.
Ribbon Cable Orientation:
Install with cable exiting DOWN, as shown.
Figure 1
Figure 3
Figure 2
Outside of
door
Ground
wire
8-32 Flat head
s
Weather
Seal
Gasket
Latch
screws
Cylinder
spacer
Ribbon
cable with
connector
Outside
Escutcheon
Fire stop
plate
Weather
seal gasket
4
Ground tab (E3)
J4 - Forced/Propped
Door connector
Ground wire
Remote Power/
REX connector
Motor connector