SARGENT AL - Alarmed Exit - Manual (Page 4)

4
H. AL- 80 Series Exit Device Installation
Finish mounting exit device per instruction sheet provided
Supplied with the 546 kit are two types of rail mounting brackets (standard & flush mount)
Select appropriate mounting bracket according to rail end cap type being installed
End caps stamped SARGENT are standard and end caps stamped SARGENT 80 are flush mount
Remove nut on mounting bracket, place lug from green wire on 546 harness on to center screw on
mounting bracket, then re-install nut and tighten
Plug rail connector(s) into raceway connector(s). Then feed through 1" hole in door
Install rail mounting bracket with two screws supplied. Install rail end cap
To ensure trouble free operation, check that the push rail can be fully depressed.
On vertical rod exit devices, adjust rods and check that the latch bolts do not go into
hold back position until the push rail is fully depressed
Plug raceway connector(s) into electric hinge connector(s) then feed through door prep
Note: Electric hinge will have two 8-pin connectors or two 8-pin and two 4-pin connectors
Mount electric hinge to door side only
Go to (A) if wiring now. Go to (B) if wiring is to be done later
A. Determine which Remote Options need to be wired per facility requirement
Refer to Remote Options Table and Wiring
Wire to loose wires on pigtail harness(es) as required using connectors allowed
by local code. Plug pigtail harness connector(s) into electric hinge connector(s)
Feed harnesses through frame prep and mount electric hinge
Ensure wiring is correct then apply power and test exit device
Refer to page 6 of this instruction and instruction A7224B for rail operating instructions
B. Plug pigtail harness connector(s) into electric hinge connector(s)
Feed harness(es) through frame prep and mount electric hinge
1
2
3
4
Pigtail harness assemblies
with 8 & 4-pin connectors
(shown). Pigtail harnesses
with 8-pin connectors only
may be supplied depending
on application
Raceway harness with
8 & 4-pin connectors
and 3 loose wires
4
AL- 80 Series Rail
with 8 & 4-pin
connectors
2
1
Mounting
bracket
1" dia
hole
in door
Screw
location
3
Electric hinge with 8 &
4-pin connectors (shown).
Electric hinge with 8-pin
connectors only may be
supplied depending on
application
Standard mounting bracket
Flush mount type
mounting bracket
*Refer to step 2 and select
appropriate mounting bracket
A7251C
Copyright © 2004, 2006, 2008, 2009, 2012, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.