SARGENT 776 Controls - Manual (Page 3)

773 - 776 ET (Solenoid Only) Installation and wiring instructions
NOTE: Lock, raceway, electric hinge and pigtail 8-pin terminations/wire colors all match .
1. Install door. Plug electric hinge and lock 8-pin connectors into raceway 8-pin connectors during lock and
hinge installation.
2. Wire to pigtail harness.
3. Ensure proper supply voltage is being applied at pigtail harness.
CAUTION: The DC voltage applied must not exceed 13.5VDC for 12 Volt models and 27VDC for 24 Volt models.
If the applied voltage exceeds either of these values, the solenoid may be damaged.
4. Plug pigtail harness 8-pin connector into electric hinge 8-pin connector.
5. Test lock – Fail Secure – Power on Unlocks; Fail Safe – Power on Locks
8
7 6
5
Plug in
here
4
3 2
1
8
7
Red (+), 2
Black (-), 1
6
5 4
3 2
1
Pigtail harness
(2 wires with
8-pin connector)
Black (-)
Red (+)
Electric Hinge
with 8-pin connectors
Red (+), 2
Black (-), 1
773, 774, 775 or 776ET
(solenoid) lock
with 8-pin connector
Raceway harness
with 8 & 4-pin
connectors
The 4-pin
connectors are
not used in
this application
Sample wiring for 773 - 776ET 24VDC solenoid locks with a 24VDC Regulated and Filtered Power Supply.
(A 12V solenoid lock requires a 12VDC power supply)
3540
24VDC
2.0 AMP
Regulated and Filtered
Power Supply
Input
L N
120VAC
60HZ
120VAC L/N/G
GND
+ - + -
24VDC
Output 1 Output 2
Normally Closed Fire
Alarm Contact (If
Required)
C
NO
NC
relay contacts
*
Switch or
Pigtail harness
(2 wires with 8-pin connector)
Red (+), 2
Black (-), 1
* Note: Wire 773 or 775 (Fail Safe) locks to switch as
shown. For 774 or 776ET (Fail Secure) locks, wire
switch NO (normally open) contact to red wire of
pigtail harness.
8
7 6
5 4
3 2
1
Plug into
8-pin hinge
connector
at door
3 1-800-810-WIRE • www.sargentlock.com • A7725B
Copyright © 2013, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
3/4/13