Great Plains 2025P Operator Manual - Manual (Page 69)

8/14/2006 118-928M
67 Maintenance and Lubrication
Refer to Figure 89
6. Check for excess wear on meter slide (1).
Slight wear at the top corner is normal.
7. If slide is not excessively worn, stop here. If it
is, continue with the following steps to re-
place.
Refer to Figure 90
8. Remove retaining clip and pin from meter.
NOTE: Meter slide is spring loaded and the
two meter slide springs will be released when
you pull the pin. Use care not to lose pins and
springs.
9. Check removed pin for wear and replace if
worn.
Refer to Figure 91
10. Remove meter slide (1) with springs (2).
11. Place springs in new meter slide and install in
meter.
12. Reinstall seed meter wheel. Refer to page 42.
Figure 89
Meter slide location
18269
Figure 90
Meter slide retaining clip
22862
Retaining
clip
Figure 91
Meter slide 18269