Great Plains 2025P Operator Manual - Manual (Page 86)

2025P, 2020P Bedded, and
2010HDP
118-928M 8/14/2006
84
Refer to Figure 111
4. Press Function key until the Calibration win-
dow appears as shown.
5. Press up arrow key to enter calibration
mode.
Refer to Figure 112
6. This is the first window that appears in Cal-
ibration mode. Press Function key to ac-
cept, or Up key to change to metric settings.
Refer to Figure 113
7. Enter drill width here using Up/Down arrow
keys. Press Function key to advance to next
window.
Figure 111
Figure 112
Figure 113
22718
22717
22719