Great Plains PTO Kits Single-Section - Manual (Page 48)

44 Single-Section PTO Pumps Table of Contents Index Great Plains Manufacturing, Inc.
401-885M Table of Contents Index 2014-06-16
Reservoir on Fertilizer Sub-Frame
This topic applies only to kits 401-849A and 411-167A,
and planter models:
• YP625A with liquid fertilizer, or
• YP825A with liquid fertilizer.
For other kits, find the topic starting page in the table on
page 41.
Refer to Figure 50
The fertilizer sub-frame reservoir location is used with
625A/825A planters that have a fertilizer sub-frame. It
applies to kits 401-849A and 411-167A, which have this
component unique to the fertilizer sub-frame location:
401-844L 6 8 FERT HYD RES W/ FILTER
This tank weldment has a two side-facing mount
plates
and straight bolts, designed to straddle the
center rib of the fertilizer sub-frame.
75. Select one new:
401-844L 6 8 FERT HYD RES W/ FILTER
and four sets new:
802-047C HHCS 1/2-13X6 GR5
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
If the fasteners are pre-installed in the reservoir
assembly, completely remove them.
Refer to Figure 51 (which is a view from below left rear)
76. With the front face (which has the sight gauge
)
facing forward, lower the reservoir weldment down
over the forward end of the center rib
of the
fertilizer sub-frame. Position it as far forward on the
rib as possible.
77. Insert two bolts through the top holes of the
weldment plates, routing them underneath all
hydraulic hoses
present.
Insert the remaining two bolts through the lower
side plate holes, and under the frame rib.
Secure all bolts with lock washers and nuts .
Continue at “Install Flow Control Valve” on page 48.
Figure 50:
Fertilizer Reservoir 401-844L
34659
132
3
161
173
169
4
132
3
132
161
173
169
132
5
161
173
169
6
U
D
F
B
R
L
Figure 51:
Reservoir on Sub-Frame Rib
34662
4
5
161
6
173 169