Great Plains 3N-4025P Operator Manual - Manual (Page 28)

196-538M Table of Contents Index 2014-01-29
24 3N-40P Table of Contents Index Great Plains Manufacturing, Inc.
Operating Instructions
This section covers general operating procedures. It
assumes that setup items have been completed.
Experience, machine familiarity and this information
leads to efficient operation and good working habits.
Always operate farm machinery with safety in mind.
Pre-Start Checklist
Moving Chain Hazard
Pinch/Crush Hazard
Shaft Entanglement Hazard:
Be careful when working around drill while tractor is running.
Any movement detected by the radar gun (Figure 22) can
activate the Veris hydraulic drive causing motion of chains,
sprockets, shafts and seed meters.
Vision Hazard:
The DICKEY-john RVS II radar speed sensor is an intentional
radiator of RF energy. Although its radiated energy level is far
below the limits set by EN 61010-1: 1993\A2: 1995 - Chapter
12.4, it is advisable not to look directly into the face of the unit.
The radar must radiate toward the ground and at least 20 cm
(8 inches) away from a human during use to comply with the
RF human exposure limits per FCC 47 CFR Sec. 2.1091.
DO NOT mount or use the radar in a manner inconsistent with
its defined use.
❑ Review “Important Safety Information” on page 1.
❑ Lubricate the drill as indicated under Lubrication,
“Maintenance and Lubrication” on page 137.
❑ Check the tires for proper inflation according to “Tire
Inflation Chart” on page 174.
❑ Check for worn or damaged parts and repair or
replace before going to the field.
❑ Check all nuts, bolts and screws. Tighten bolts as
specified on “Torque Values Chart” on page 175
❑ Check hydraulic hoses, fittings and cylinders for
leaks. Tighten, repair or replace before planting.
High Pressure Fluid Hazard:
Escaping fluid under pressure can penetrate skin, causing
serious injury. Avoid the hazard by relieving pressure before
disconnecting hydraulic lines. Use a piece of paper or
cardboard, NOT BODY PARTS, to check for leaks. Wear
protective gloves and safety glasses or goggles when working
with hydraulic systems. If an accident occurs, seek immediate
medical attention from a physician familiar with this type of
injury.
Figure 22
DICKEY-john Radar
20310