Great Plains 3N-4025P Operator Manual - Manual (Page 61)

Great Plains Manufacturing, Inc. Table of Contents Index Hydraulic Drive Operation 57
2014-01-29 Table of Contents Index 196-538M
GPS-Based Planting
Refer to Figure 83
Both the Farmworks SiteMate computer and the Ag
Leader PF3000 GPS solutions require a 9-pin serial
connection
to the hydraulic drive console.
FarmWorks SiteMate
Settings for FarmWorks SiteMate used with Precision
Population Controller QUICK REFERENCE GUIDE
1. Create a .shp recipe file in FarmWorks Site Pro,
SMS 2.0, SSToolbox, or other software that will
create a .shp file, and transfer it to SiteMate.
SiteMate Settings: (version 8.12)
1.
Select CONFIGURE Tab.
Select SETTINGS.
Select VARIABLE RATE SETUP.
Select NEW.
Type in GP PPC.
Under CONTROLLER TYPE, select
Rawson from the scroll-down list.
Under COMM PORT select the port number for the
serial card or flash jacket port.
2. Select MAP tab.
Enter DEFAULT rate.
This is the rate that SiteMate calls for if GPS signal is
lost or you are outside the map area.
3. Note: if GPS signal is interrupted, or you are outside
the map area, the Controller continues applying at
the latest rate, until signal is regained, or another
rate is set manually. If SiteMate power is interrupted,
restart the recipe to return to VR.
4. In the CONVERSION window, enter the conversion
rate as 1.
5. Under the APP tab,
enter the Feed Delay as 3 seconds.
Measure the distance from the GPS to the seed
tubes.
Enter the measurement in the Following Distance
window.
Enter the Swath Width of the Great Plains unit.
6. Under the CTRL tab,
enter the Nominal Rate as follows:
Divide the highest rate on your recipe by 1.6.
This is your Nominal rate.
If your highest rate is 32, your nominal rate is 20.
Enter the Step as 4%.
Exit VRA Controller Setup by clicking OK button to
save the settings.
7. Under FILE,
Open VRT and select the
Rx Map (recipe) for the field.
Press the SETUP button and select the PPC
controller option you set up using these instructions.
8. Press GO.
The Rx rate window shows the rate that is being sent
to the GP Precision Population Controller. The
APPLIED window shows the rate that the GP
Controller is applying.
Figure 83: SiteMate:
Serial Connection to Controller
28322
1
1