Bio-Rad EXQuest Spot Cutter - Manual (Page 18)

Figure 2-5. Installed microplate rack.
2.6 CABLE SETUP
Before the spot cutter can be started, the power cord and USB cable must be connected.
1. Connect the square end of the USB cable to the EXQuest spot cutter hub labeled "Host PC",
located on the instrument right side (see Figure 2-6, below).
2. Connect the other end of the USB cable to any USB port on the host computer.
3. Connect the AC power cord to the EXQuest spot cutter power entry module, located on the
instrument right side.
4. If an accessory bar code reader will be used with the spot cutter, plug it into one of the peripheral
USB ports on the spot cutter or computer.
SYSTEM INSTALLATION
2-5