Bio-Rad EXQuest Spot Cutter - Manual (Page 24)

4. Click Setup spot cutter… to start the "EXQuest Calibration Wizard". The screen that will appear
depends on the current calibration state of the instrument.
Spot Cutter Is Not Calibrated
If the spot cutter is not currently calibrated, the "EXQuest Calibration Wizard" screen will appear as shown if
Figure 3-3. From this screen, click Next to focus the camera (see Step 5, below).
Figure 3-3. “EXQuest Calibration Wizard” screen – uncalibrated.
Spot Cutter Is Calibrated
If the spot cutter is currently calibrated, the "EXQuest Calibration Wizard" screen will appear as shown in
Figure 3-4.
EXQUEST CALIBRATION WIZARD
3-2