Bio-Rad Econo Gradient Pump Kits - Manual (Page 31)

Model 2128 Fraction Collector (continued)
Alternatively, one may use the Model 2128 Diverter
Valve; it will respond to the program in the Model
2128 Fraction Collector itself, not from the EGP.
If HOLD is selected during the program, then the
pump will continue pumping at the current conditions
and fraction collection will continue as programmed.
If PAUSE is selected during the program, then the
pump and fraction collector will stop.
The pump and fraction collector will resume when
CONTINUE is selected.
Model 2110 Fraction Collector
1. This cable connects the EGP (mini-DIN I/O
socket) to the 9-pin D-connector on the Model
2110 Fraction Collector and transmits “start” and
“stop” signals.
If the Model 1327 Chart Recorder is present,
connect the cable’s remaining end to the chart
recorder. If the chart recorder is not present,
then place this portion of the cable aside.
2. Power up the EGP and the fraction collector (and
the chart recorder, if present.)
3. Select collection by time or by drops by pressing
the Time/Drop key on the fraction collector’s
faceplate.
When the EGP is running in Manual mode, the
2110 fraction collector will not start automatically.
It may be started from is own faceplate if fraction
collection is required.
Other Instruments
27
Cable #22
Catalog #
731-9010
4006161B.qxd 8/14/2003 8:09 AM Page 27