BlueAnt S1 Sun Visor Handsfree Kit - Manual (Page 21)

21
Button Functions
To... Do This... Notes
Switch the S1 On Hold for 1 second (until
the Bluetooth Light flashes blue).
You will hear a beep indicating that
the S1 is switching on.
Switch the S1 Off Hold for 5 seconds
(until the Bluetooth Light turns red).
You will hear a beep indicating that
the S1 is switching off.
Enter Pairing Mode With the S1 off, hold for
about 5 seconds (until the Bluetooth
Light starts flashing red and blue).
You must switch the S1 off first
before you can enter pairing mode.
Answer an Incoming
Call Click You can also accept an incoming
call with your voice. For more
information, see
"Answering
Calls" (page 8) .
Reject an Incoming Call Click Although you can answer calls with
your voice, you can only reject a call
using the button.
End the Current Call Click You can also end the call by using
your phone's end call button.
Use Phone Voice
Dialing Hold for 1 second. You can only use this function if
your phone supports voice dial
functionality.
You may need to record voice tags
on your phone to use this feature:
see your phone's manual for more
details.
Redial the Last
Outgoing Call Hold for 3 seconds. If you have two phones connected,
the S1 will redial the last outgoing
call on the primary phone. See
"Using More Than One Phone At
The Same Time (Multipoint)" (page
15)
for more information.
Adjust the Volume Click "Vol +" or "Vol -" The Bluetooth Light will turn violet
when you reach the minimum and
maximum volume level.