Edge Lighting TruLine .5A, 24VDC - Plaster-In LED System - Manual (Page 11)

11
22: Using the marked locations on the drywall, carefully make
holes in the channel flange using the provided square drill
with counter sink bit.
23: Secure the channel using drywall screws. Ensure all
screws are flush to the channel.
DRYWALL
SCREWS
CHANNEL
23
24: Apply ultra-thin drywall tape along edges of channel to
prevent cracking of plaster after installation.
NOTE: Test the LED strip before any plaster work is done.
NOTE: Cover the channel opening with contractor’s tape
before plastering.
ULTRA-THIN
DRYWALL TAPE
CONTRACTOR'S
TAPE
25: Use a 12" compound knife for a smooth compound spread.
Sand, paint, and finish the plaster and drywall before
removing the contractor’s tape.
26: Remove the blue contractor’s tape from the inside of the
channel. Clean the channel surface with alcohol to remove
any dust or debris before continuing.
27: Attach the trap door frame to the junction box using a #4-
40 screw.
28: Attach the trap door to the junction box using a #4-40 screw.
IMPORTANT: Soft strip may not properly adhere to channel
surface unless the channel is cleaned with alcohol prior to
application.
PLASTER
25
CONTRACTOR'S
TAPE
12"
COMPOUND
KNIFE
24
Z10 Z11
Z12 Z13
#4-40
SCREW
TRAP
DOOR
TRAP
DOOR
FRAME
26
27
28