Edge Lighting TruLine .5A, 24VDC - Plaster-In LED System User Manual
Page 12
12
29: Line up the red wire side of the power connector with the
“+24VDC” marking on the Soft Strip. Push the male connector
of the Soft Strip into the female connector of the power cables.
30: Carefully remove the backing from the LED soft strip, making
sure not to remove the tape from the soft strip.
31: Firmly press down the adhesive portion of the soft strip onto
the channel surface while removing the rest of the backing,
making sure there are no air bubbles that can cause surface
irregularities.
Z14
LED SOFT
STRIP
POWER
CONNECTOR
29
31
32: Continue removing the paper backing from the soft strip
and installing along channel, pressing adhesive into
place using ONLY a finger.
33: Bend the soft strip to match the installation corner.
34: If required, trim the soft strip on the dashed cutting lines
ONLY. Ensure the entire length of the channel is covered
with Soft Strip to avoid unlit areas. Place any excess soft
strip inside the take-up box.
Z15
Z16
30
PAPER
BACKING
32
33
34
34
BEND SOFT
STRIP TO
FOLLOW
CORNER
TAKE-UP
BOX