Jeppesen JeppView 3 - Manual (Page 151)

JeppView User's Guide
154
TIP
When you apply a route corridor filter, JeppView takes a “snapshot” of the
area around the route. If you modify the route, reapply the filter settings by
right-clicking the route and selecting Show Approaches Within.
All geographic filters apply a yellow border in the Enroute Charts View that depict the
boundary of the filtered area, while the Airport List contains only airports within the
selected geographic area.
Filtering Airports Using the Enroute Chart
This is often much easier than trying to type in the values for these filters as shown
above. You can return to the filter settings dialog box if needed to refine the filters
you apply graphically.
To apply a rectangle filter:
1. Zoom and pan the Enroute Charts View to show the area within which you
want airports listed in the Airport List.
2. Right-click an open area on the enroute chart and choose Use View as
Geographic Area Filter.
To set a circle or corridor filter:
1. Right-click any airport, navaid, route waypoint, or route on the enroute chart
and choose Show Approaches Within.