Jeppesen JeppView 3 - Manual (Page 175)

JeppView User's Guide
178
The RoutePack Wizard enables you to create a RoutePack by guiding you through a
series of dialog boxes that creates routes with alternate airports and waypoints (if
desired).
NOTE
The RoutePack Wizard opens when you first start JeppView unless you
disable it. To re-enable it, select Show this Wizard at Startup after
opening the RoutePack Wizard.
To create a RoutePack using the RoutePack Wizard:
1. Open the RoutePack Wizard by doing any of the following:
• Click Tools > RoutePack Wizard.
• Click the RoutePack Wizard button on the Chart toolbar.
2. Enter the airport identifiers (ICAO or IATA) for your RoutePack in the
Departure and Destination airport fields. When the airport identifier is
recognized, the airport name appears to the right of the field. If you enter a
partial entry or an unrecognized identifier, the Tab to select waypoint
command appears.
To enter the correct identifier:
A. Press TAB.
B. In the Select an Item dialog box, select the appropriate waypoint from
the list.
C. Click OK. The RoutePack Wizard dialog box opens with the correct
identifier in the field.
D. Departure and Destination are required fields. When both airports have
been entered, a green dashed route line depicting the route appears in the
Enroute Charts View.