Jeppesen JeppView 3 - Manual (Page 185)

JeppView User's Guide
188
• 015M indicates magnetic bearing.
• 67.45 NM indicates distance.
• 750/1000 ft indicates the approximate lowest and highest terrain
between the last route waypoint and the mouse pointer.
TIP
To change the distance units on the point and click display, click Tools >
Options > Measurement and select a new unit from the Distance drop-
down list.
As waypoints are selected, the new route displays in blue on the enroute chart
and each waypoint appears in the RoutePack List.
5. To finish the route, do either of the following:
• Right-click an open space on the enroute chart and choose Stop
Appending Waypoints.
• Press ESC.
Once created, you can insert , append , and delete waypoints in the route, as well as
reverse and print your new route.
Adding a Route to a RoutePack
A route is a collection of waypoints that contains a departure and destination airport,
but it may also include enroute waypoints and alternate routes. Routes are created
and stored in a RoutePack. You can add a route to a RoutePack by using either the
point-and-click method or the Route Wizard.
Adding a Route Using the Point-and-Click Method
The point-and-click method allows you to designate any point on an enroute chart as
a route waypoint. JeppView creates a route waypoint wherever you click the enroute
chart. To create a route using the point-and-click method:
1. Open the Route Properties dialog box by doing any of the following:
• Right-click a RoutePack in the RoutePack List and choose Add Route
(Point/Click). The Route will be added to the RoutePack on which
you right-click.
• Right-click an open area in the RoutePack List and choose Add Route
to '[Selected RoutePack]' (Point/Click). This adds a route to the
RoutePack that is currently selected in the RoutePack list.