Jeppesen JeppView 3 - Manual (Page 184)

RoutePacks and Route Planning
187
When the Append Waypoints function is active, the pending route appears as a
dashed line on the Enroute Charts View. Once you select the next waypoint,
the new route appears in blue and each waypoint appears in the RoutePack
List. Waypoints other than the departure and destination are not required.
5. To finish the route, right-click in the Enroute Charts View or the RoutePack
List, and choose Stop Appending Waypoints.
Once created, you can insert , append , and delete waypoints in the route, as well as
reverse and print your new route.
Graphical Routing (Point and Click)
The point-and-click method allows you to designate any point on an enroute chart as
a route waypoint. JeppView creates a route waypoint wherever you click the enroute
chart.
To build a route visually in the Enroute Charts View, first load an existing RoutePack
or create a new RoutePack .
1. To begin, do one of the following:
• Right-click a RoutePack in the RoutePack List and click Add Route
(Point/Click). A new route is added to the RoutePack on which you
right-clicked.
• Right-click in the RoutePack List window and click Add Route to
'[Selected RoutePack]' (Point/Click). This adds a route to the
currently selected RoutePack in the RoutePack list.
• Right-click in the Enroute Charts view and click Add Route to
'[Selected RoutePack]'. This adds a route to the currently selected
RoutePack in the RoutePack list.
• Click File > Add Route to '[Selected RoutePack]'. This adds a
route to the currently selected RoutePack in the RoutePack list.
The Route Properties dialog box contains information about the route such as
the distance, alternate airports, waypoints, and charts. The only active field is
for the route name.
2. Accept the default name or type a new one in the Name field, and then click
OK. The new route appears in the RoutePack List. You can now point and
click the enroute chart to add waypoints to your route.
3. In the enroute chart, click the symbol for your departure airport. The selected
waypoint appears in the RoutePack List under your route. You can also click
any area of the enroute chart to create a new waypoint. These are
designated in the RoutePack List and on the enroute chart as WP 1, WP 2,
etc.
4. Select the route waypoints (if any) in sequence and then your destination
airport. When the Append Waypoints function is active, moving the mouse
around the chart displays a dashed line with information about the proposed
leg and waypoint.
• 012T indicates the true bearing from the last route waypoint to the
pointer.