Dell PowerVault 50F (Fibre Channel Switch) - Manual (Page 11)

Installing the PowerVault™ 50F Switch: Dell™ PowerVault™ 50F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
file:///C|/Users/sharon_anand/Desktop/PowerVault/50f_enit/INSTALL.HTM[3/15/2013 11:31:55 AM]
2. Tighten the thumbscrews on the L-brackets to secure the switch to the rack.
3. Install the bezel onto the front of the rack, as shown in Figure 1-5.
The captive thumbscrews of the bezel pass through the rail holes and into the middle hole of the
adjustable brackets. Adjust the bezel so the manifold slides part way into it.
Stand-alone Mounting
The switch is shipped in its stand-alone configuration. Adhesive rubber feet are supplied if the switch is
surface-mounted. Installation of the rubber feet is optional, and is not required for proper or safe switch
operation.
To install the adhesive rubber feet, perform the following steps:
1. Use the alcohol wipes provided to clean the four depressions at each corner of the chassis bottom.
Allow the alcohol to dry.
2. Remove the rubber feet from the backing sheet and place one in each depression.
3. Firmly press the rubber feet in place.
NOTE: If rubber feet have been installed, they must be removed before the unit can be installed in a 19-inch rack.