Dell PowerVault 50F (Fibre Channel Switch) - Manual (Page 66)

PowerVault™ 50F Commands: Dell™ PowerVault™ 50F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
file:///C|/Users/sharon_anand/Desktop/PowerVault/50f_enit/COMMANDS.HTM[3/15/2013 11:32:02 AM]
but may differ because of failure modes.
Port 16 is the embedded port.
Figure 7-20. diagShow Command Example
Table 7-11. diagShow Command Field Descriptions
Field Description
Diag Port
Status The port status
port# The port number
diags Possible values include OK, BAD.
state Possible values include UP (online), DN (offline.)
st0-16 The tested chips. The display shows the diagnostics frames are
transmitted and received and Low Level Interface counts
(LLI_errs).
Note that port 16 is the embedded port.
Central Memory
Status The central memory status. Possible values include OK, FAULTY.
Total Diag Frames Tx The total diagnostics frames transmitted (Tx) since boot. This
number usually corresponds to the total frames received (Rx) but
may differ because of failure modes.
Total Diag