Dell PowerVault 50F (Fibre Channel Switch) - Manual (Page 52)

PowerVault™ 50F Commands: Dell™ PowerVault™ 50F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
file:///C|/Users/sharon_anand/Desktop/PowerVault/50f_enit/COMMANDS.HTM[3/15/2013 11:32:02 AM]
tsum Test checksum
dsum Data checksum
hsum Header checksum
h
The h command prints the shell history of the previous 20 commands. The older commands are replaced by
new commands. The shell history is similar to the UNIX Korn shell history facility with a built-in line editor
(similar to UNIX vi) that allows previously typed commands to be edited.
The shell history is reset by a reboot.
help
NOTE: The help display changes depending on the login user level and will display only those commands that are
available to the current user. This example shows admin level commands. Route and license commands are not supported
by Dell.
The help command prints a list of commands in alphabetical order, with an additional lists of "grouped"
commands as follows:
General commands
Diagnosis commands
Routing (Show) commands
License commands
NOTE: In addition, commands for optionally licensed products are only displayed if the appropriate license key has been
installed.
i
The i command prints a currently running task summary. The i command is for diagnostic purposes is run
only when requested by Dell Technical Support.
ifShow
The ifShow command prints network interface information. The display includes three sections organized by
interface:
ei - Ethernet 10-BaseT port
lo - loopback interface
fc - Fibre Channel. This section is omitted if IP over Fibre Channel is not configured
ipAddrSet
The ipAddrSet command is used to set the switch's IP addresses. The fields are described in Table 7-5.
NOTE: Consult your network administrator for the appropriate subnetmask.