Mxm assembly (optional), Removing the mxm assembly, Replacing the mxm assembly – Dell Inspiron One 2305 (Mid 2010) User Manual
Page 55
Back to Contents Page
MXM Assembly (Optional)
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the MXM Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the back cover (see
Removing the Back Cover
).
3.
Follow the instructions from
step 2
to
step 5
in
Removing the Front Stand
.
4.
Remove the system-board shield (see
Removing the System-Board Shield
).
5.
Remove the MXM-assembly fan (see
Removing the MXM-Assembly Fan
).
6.
Remove the three screws that secure the MXM-assembly to the chassis.
7.
Remove the MXM assembly from the MXM-assembly connector.
Replacing the MXM Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Align the notch on the MXM assembly with the tab in the MXM-assembly connector.
3.
Insert the MXM assembly at a 45-degree angle into the MXM-assembly connector.
4.
Replace the three screws that secure the MXM assembly to the chassis.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
The MXM assembly may be very hot during normal operation. Ensure that it has had sufficient time to cool before you touch it.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
NOTE:
The appearance of the system board may vary based on your computer model.
1
MXM assembly connector
2
MXM assembly
3
screws (3)