Dell Inspiron One 2305 (Mid 2010) User Manual
Page 64
4.
Route the antenna-in connector cable and infrared (IR) blaster connector cable through the routing guides on the system-board shield.
5.
Connect the IR blaster connector cable to the connector (CIR Emitter) on the system board.
6.
Connect the antenna-in connector cable to the connector on the TV tuner card.
7.
Carefully turn the system-board shield over and align the screw holes on the system-board shield with the screw holes on the chassis.
8.
Replace the four screws that secure the system-board shield to the chassis.
9.
Follow the instructions from
step 4
to
step 5
in
Replacing the Front Stand
.
10.
Replace the back cover (see
Replacing the Back Cover
).
11.
Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.