Antenna-in connector, Removing the antenna-in connector, Replacing the antenna-in connector – Dell Inspiron One 2305 (Mid 2010) User Manual
Page 87
Back to Contents Page
Antenna-In Connector
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Antenna-In Connector
Replacing the Antenna-In Connector
Removing the Antenna-In Connector
1.
Follow the instructions in
Before You Begin
.
2.
Remove the back cover (see
Removing the Back Cover
).
3.
Follow the instructions from
step 2
to
step 5
in
Removing the Front Stand
.
4.
Follow the instructions from
step 4
to
step 8
in
Removing the System-Board Shield
.
5.
Remove the hex nut that secures the antenna-in connector to the system-board shield.
6.
Release the antenna-in connector from the slot on the system-board shield.
7.
Lift the antenna-in connector along with its cable away from the system-board shield.
Replacing the Antenna-In Connector
1.
Follow the instructions in
Before You Begin
.
2.
Slide the antenna-in connector into the slot on the system-board shield.
3.
Replace the hex nut that secures the antenna-in connector to the system-board shield.
4.
Follow the instructions from
step 4
to
step 8
in
Replacing the System-Board Shield
.
5.
Follow the instructions from
step 4
to
step 5
in
Replacing the Front Stand
.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
antenna-in connector
2
hex nut