Services for novell® netware, Restarting workstation services, Enabling services for netware – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 101
6. Enter the user name and password you created in step 1, and then click OK.
7. Select the Microsoft UAM Volume, and then click OK.
8. Close the Chooser dialog box.
To install the authentication files on the Macintosh workstation, perform the following steps:
1. Double-click Microsoft UAM Volume on the Macintosh desktop.
2. Double-click the Microsoft UAM Installer file on the Microsoft UAM volume.
3. Click Continue in the Installer Welcome screen.
The installer reports whether the installation succeeds.
If the installation succeeds, Macintosh users of this workstation are offered Microsoft Authentication when they connect to the
system.
Restarting Workstation Services
If File Services for Macintosh cannot establish communications to the local RPC service, you may need to restart the
Workstation Service.
To restart the Workstation Service, perform the following steps:
1. Log in to the NAS Manager.
2. Click Maintenance, and then click Terminal Services.
3. Log in to the NAS system as an administrator.
NOTE:
The default administrative user name is administrator and the default password is powervault.
The Advanced Administration Menu displays. If it does not display, double-click the Advanced Administration Menu
icon on the desktop of the NAS system.
4. Click System Management, and then click Computer Management.
5. Click Services and Application.
6. Double-click Services.
7. Right-click Workstation in the Services window, and select Restart.
8. Confirm that you want to restart the Workstation Services.
Services for Novell® NetWare®
Services for NetWare (SFN) are compatible with Novell NetWare Bindery service for authentication and file access using the
internetwork packet exchange/sequenced packet exchange (IPX/SPX) network protocol. Services for NetWare are disabled by
default. See "
Enabling Services for NetWare
The NetWare protocol is disabled on the NAS system by default. You must enable the NetWare protocol for NetWare clients to
access the NAS system.
To enable the NetWare protocol, perform the following steps: