Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 89
4. Log in to the system as an administrator.
NOTE:
The default administrator user name is administrator and the default password is powervault.
5. On the Advanced Administration Menu, click System Management, and then click Set Regional Options to
launch the Regional Options control panel.
6. On the General tab, select the MUI language from the Your locale (location) drop-down menu, and then click
Apply.
7. Log off and log in to the system again for the new language MUI to take effect.
Installing and Configuring Support for Other Languages
NOTE:
Install additional language locales only if your preferred language is not available with MUI support or you need
additional locale support.
The Windows Powered operating system that comes installed on your NAS system can be configured to support reading and
writing documents in a number of languages. To install the software required to support a specific language, perform the
following steps:
1. Insert the Multilingual Support CD into the NAS system's CD drive.
2. From a client system, log in to the NAS Manager.
3. Click Maintenance.
4. Click Terminal Services.
5. Log in to the system as an administrator.
NOTE:
The default administrator user name is administrator and the default password is powervault.
6. Close the Advanced Administration Menu by clicking Exit and then clicking OK.
7. Double-click My Appliance on the NAS desktop.
8. Browse to the CD drive and double-click Dell PowerVault Multilingual Support CD to launch the CD's web
interface.
9. Click the Install Language Locales Not Supported by MUI link to launch the Regional Options control panel.
10. From the Language Settings for the System panel, select the languages to be configured.
11. Set the default language for the system by clicking Set default... and selecting the appropriate language from the
menu, and then click OK.
12. Click Apply to complete the operation.
13. If the Insert Disk window appears, you must perform the following steps:
a. Click OK.
b. In the Files needed window, click Browse, browse to the i386 directory on the Multilingual Support CD, and
then click Open.
c. Click OK from the Insert Disk window to allow the operating system to find the required files for installation.
14. After the installation is complete, you must reboot your system.