Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 11)

i. Click Next.
j. Select the port to which you want to install the modem, and then click Next.
k. Enter the area code in the Localization Information window, and then click Next.
l. Click Finish to complete the modem installation.
m. In the Add RAS Device window, click COMx - Dial-Up Networking Serial Cable Between 2 PCs, and click
OK.
n. In the Remote Access Setup window, select Dial-Up Networking Serial Cable between 2 PCs, and click
Continue.
o. Click Dial out only and click OK.
p. In the Remote Access Setup window, select Dial-Up Networking Serial Cable between 2 PCs, and click
Network.
q. Deselect NetBEUI and IPX as dial-out protocols, make sure that TCP/IP is selected, and click Configure.
r. Click Continue.
s. Remove the Windows NT CD from the CD drive.
t. Click Restart.
6. Log in to the client system as an administrator.
7. Configure the modem properties:
a. From the client desktop, double-click My Computer.
b. Double-click Control Panel.
c. In the Control Panel window, double-click Modems.
d. For Modem Properties, select Dial-Up Networking Serial Cable Between 2 PCs.
e. Click Properties.
f. Select 115,200 for Maximum speed and click OK.
g. Click Close.
8. Create the dial-up connection to the NAS system:
a. In the My Computer window, double-click Dial-Up Networking.
b. When a message states that your phonebook is empty, click OK to create a new phone book entry.
c. In the New Phonebook Entry Wizard, type a name for the connection to the NAS system.
d. Click I know all about phonebook entries and would rather edit the properties directly, and then click
Finish.
e. Click Configure.
f. Select 115,200 for the Initial Speed and click OK.
g. Click the Server tab, and deselect NetBEUI and IPX.
TCP/IP should be the only protocol selected.
h. Click OK.