Dell C1765NFW MFP Laser Printer - Manual (Page 161)

Understanding the Tool Box Menus 159
Fax Settings
Purpose:
To configure the basic fax settings.
Values:
Receive Mode Telephone Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external telephone, and then pressing the remote receive code.
Fax Automatically receives faxes.
Telephone/Fax When the printer receives an incoming fax, the external telephone rings for the
time specified in Auto Rec Fax/Tel, and then the printer automatically receives a
fax. If an incoming call is not a fax, the printer beeps from the internal speaker
indicating that the call is a telephone call.
Ans Machine/Fax The printer can share a telephone line with an answering machine. In this mode,
the printer will monitor the fax signal and pick up the line if there are fax tones. If
the phone communication is using serial transmission in your country (such as
Germany, Sweden, Denmark, Austria, Belgium, Italy, France and Switzerland), this
mode is not supported.
DRPD Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive
ring service must be installed on your telephone line by the telephone company.
After the telephone company has provided a separate number for faxing with a
distinctive ring pattern, configure the fax setup to monitor for that specific ring
pattern.
Auto Rec Fax Available Range:
0–255 seconds
Sets the interval at which the printer goes into the fax receive mode after receiving
an incoming call.
Auto Rec Fax/Tel Available Range:
0–255 seconds
Sets the interval at which the printer goes into the fax receive mode after the
external telephone receives an incoming call.
Auto Rec Ans/Fax Available Range:
0–255 seconds
Sets the interval at which the printer goes into the fax receive mode after the
external answering machine receives an incoming call.
Line Monitor Off Turns off the volume of the line monitor.
Low Specifies the volume of the line monitor, which audibly monitors a transmission
through the internal speaker until a connection is made.
Medium
High
Ring Tone Volume Off Turns off the volume of the ring tone.
Low Specifies the volume of the ring tone, which indicates that an incoming call is a
telephone call through the internal speaker when Receive Mode is set to
Telephone/Fax.
Medium
High
Line Type PSTN Sets the line type to PSTN.
PBX Sets the line type to PBX.
Tone/Pulse Tone Sets the dialing type to Tone.
Pulse (10PPS) Sets the dialing type to Pulse (10 pulse per second).
Pulse (20PPS) *1 Sets the dialing type to Pulse (20 pulse per second).
Resend Delay Available Range:
3–255 seconds
Specifies the interval between transmission attempts.
Redial Attempts Available Range:
0–9
Specifies the number of redial attempts to make when the destination fax number
is busy. If you enter 0, the printer will not redial.