Dell Latitude Cpi - Manual (Page 34)

28 Dell Latitude CP and CPi — Parts Removal and Replacement Guide
5. Remove the four silver 5-mm screws securing each of the two hinge
brackets to the bottom case assembly.
6. Lift the display assembly from the bottom case assembly.
NOTE: When reinstalling the display assembly, install the four screws securing
the hinges at the locations marked by arrows on the face of each hinge.

  

 

)
 
 
%  
   
 
 
     /

 
  
  
 
    
 
 
  0   

 
 
 

!
 
 " 


0 $
 8 6 .  5$
 5 7
1. Use a scribe to carefully pry the screw covers out of the six screw
holes in the bezel.
2. Remove the six screws from the bezel.
On 12.1-inch displays, all six screws are 5-mm screws. On 13.3-inch
displays, the four upper screws are 3-mm screws, while the lower two
screws are 5-mm in length.
3. Separate the bezel from the display-assembly top cover.
If removing the bezel from a 12.1-inch display — The bezel is secured by
snaps around all four of its edges. Insert your fingertips between the bezel
and the LCD panel, and lift upward on the bezel to release the hidden
snaps. Avoid pressing on the surface of the LCD panel.
screw covers (6)
display assembly bezel
display-assembly
top cover
5-mm screws (4) (12.1-inch displays);
3-mm screws (4) (13.3-inch displays)
5-mm screws (2)