Dell Latitude Cpi - Manual (Page 51)

Dell Latitude CP and CPi — Parts Removal and Replacement Guide 45

  .!% .  - !.$ 


7. Remove the three screws that secure the microprocessor module to
the system board.
8. Use a processor extractor tool to remove the microprocessor module.
The tool fits on the left side of the module, in the notches.

 /     
  3      

  
  7
  
 
9. Remove the air flow duct.
10. Verify that the PC Card ejectors do not extend from the PC Card bay.
11. Remove the 2.5-mm screw from the center of the computer’s left rear
foot.
two-slot hold-down clip
slots
microprocessor-module fence
one-slot hold-down clip
slot