Dell Latitude Cpi - Manual (Page 50)

44 Dell Latitude CP and CPi — Parts Removal and Replacement Guide

     7
 

   

%  

        

   


  '

    


   
 
5. Remove the thermal cooling subassembly from the microprocessor
module.
6. Remove the processor hold-down clip, if one is attached to the
microprocessor module fence.
Your computer may have a one- or two-slot hold-down clip. One tab locks
the one-slot hold-down clip to the fence. Two tabs lock the two-slot clip to
the fence. To remove the clip, perform the following steps to bend the
tabs away from the fence:
a. Insert a small flat-blade screwdriver into one of the slots at the top of
the clip (see Figure 31).
b. Bend the tab away from the fence by carefully tipping the screwdriver
away from the microprocessor module.
c. If your computer has a two-slot hold-down clip (see Figure 31), repeat
substeps a and b for the second slot.
d. Lift the clip off the fence and discard it.