Dell Latitude Cpi - Manual (Page 53)

Dell Latitude CP and CPi — Parts Removal and Replacement Guide 47
+, 
-

 ()5
 
1. Remove the palmrest assembly.
2. Disconnect the exhaust fan power cable from connector JFAN1 on
the system board.
3. Remove the two 12-mm screws securing the exhaust fan, and then
remove the exhaust fan.
NOTE: When replacing the exhaust fan, orient the fan such that the fan label
faces outward and the power cable is at the upper right corner of the fan
(when viewed from the back of the computer). (This will prevent the fan wires
from being pinched when you reassemble the computer.) Make sure that the
wires are routed below the upper EMI shield.
exhaust fan
12-mm screws (2)
exhaust fan power cable
connector (JFAN1)