Dell Latitude Cpi - Manual (Page 41)

Dell Latitude CP and CPi — Parts Removal and Replacement Guide 35
!
 
  








 $
.  " 
 
6 .  5$
 5 7
1. Remove the display assembly.
2. Remove the LCD panel.
3. Disconnect the display-assembly interface cable from ZIF connector
J1 on the LCD inverter board.
4. Remove the two 5-mm screws securing the left hinge, and then
remove the hinge from the display-assembly top cover.
5. If you are removing the display-assembly interface cable from a
13.3-inch display, remove the left top-cover brace from the
display-assembly top cover (see Figure 22).
To remove the top cover brace, remove the 3-mm screw securing it.
6. Lift the display-assembly interface cable out of the display-assembly
top cover.
NOTE: When replacing the display assembly, reinstall the screws securing the
left hinge at the locations marked on the hinge by arrows. Ensure that the
display-assembly interface cable wraps once around the plastic bobbin before
connecting the cable to the system board.
#
!

 $
1. Remove the LCD display assembly from the computer.
2. Remove the display assembly bezel.
display-assembly interface cable
connector J1
left hinge
plastic bobbin
5-mm
screws (2)