Dell Latitude Cpi - Manual (Page 44)

38 Dell Latitude CP and CPi — Parts Removal and Replacement Guide


  
% 
 &
'(
 &
 &

 
 )

'  !$  
NOTE: You do not need to remove the main battery or hard-disk drive prior to
this procedure.

 &'    '  


     




 
 
1. Close the display and turn the computer over.
2. Remove the device from the modular bay.
Push the modular bay latch away from the center of the computer. Keep
holding the latch open while pulling the device out of the modular bay with
the other hand.

*  

1. Remove the palmrest assembly.
2. Remove the 5-mm screw securing the audio board shield (see
Figure 26).
3. Remove the audio board shield.
NOTE: When replacing the audio shield, ensure that the audio shield is
properly seated to prevent it from cutting into the speaker wires or interfering
with devices installed in the modular bay. (You can check this by temporarily
installing a device in the modular bay prior to reinstalling the palmrest
assembly.)
latch lock