Dell Latitude Cpi - Manual (Page 39)

Dell Latitude CP and CPi — Parts Removal and Replacement Guide 33
#
 

The following subsections describe how to remove an LCD inverter board from
a 12.1-inch or 13.3-inch LCD display.





 9
$  ! 6 .  5$
7
1. Remove the display assembly bezel.
2. Disconnect the LCD-assembly power cable from connector J2 on the
LCD inverter board.
3. Disconnect the display-assembly interface cable from ZIF connector
J1 on the LCD inverter board.
4. Remove the two silver 5-mm screws and plastic spacers securing the
LCD inverter board.
Note the placement of the EMI shield over the lower screw boss, and the
routing of the LCD-panel power cable around the upper screw boss.
5. Lift the LCD inverter board out of the display-assembly top cover.
NOTE: When installing the inverter board, connect the LCD interface cable to
the board prior to securing the board in the display-assembly top cover. After
installing the inverter board, ensure that the LCD-panel power cable is routed
around the plastic screw bosses in the display-assembly top cover.
LCD inverter board
display-assembly top cover
connector J1
connector J2
5-mm
screws (2)
spacers (2)
LCD-assembly
power cable