Dell XPS One 2710 (Mid 2012) - Manual (Page 133)

Removing the Display Panel | 133
60 Removing the Display Panel
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Prerequisites
1 Remove the back cover. See "Removing the Back Cover" on page 19.
2 Remove the stand. See "Removing the Stand" on page 47.
3 Remove the system-board shield. See "Removing the System-Board Shield" on
page 31.
4 Remove the trim cover. See "Removing the Trim Cover" on page 87.
5 Remove the processor heat-sink fan. See "Removing the Processor Heat-Sink Fan"
on page 75.
6 Remove the inner frame. See "Removing the Inner Frame" on page 95.
Procedure
1 Disconnect the power-button cable from the system board and remove the
power-button cable from its routing guides.
2 Disconnect the speaker cable from the system board and remove the speaker cable
from its routing guides.
3 Disconnect the antenna cables from the wireless mini-card and remove the
antenna cables from their routing guides.
4 Disconnect the camera and infrared-module cables from the system board and
remove the cables from their routing guides.
5 Disconnect the display-power, touchscreen, and LVDS cables from the
system board.
OM_Book.book Page 133 Friday, April 27, 2012 3:23 PM